THE ULTIMATE SNEAKER CLEANING SYSTEM ...AND SO MUCH MORE

w'air uses cold tap water and a little detergent to spot clean, deep clean or simply refresh...

or why not try your w'air on other things

and always remember the w’air three golden rules

1

The sooner you treat items with your w'air, the better the results will be

2

Always use the correct w’air products – using the wrong products will damage your w’air and you may invalidate your warranty

3

If in doubt about how to use your w'air, download the app (via iOS or Android), use the QR code above or visit frequently asked questions

 

how to use your device, step by step

  • Getting
    started
  • Remove
    stains
  • Deep clean
    delicates
  • Refresh
    clothes & fabrics
 
  1. Remove your w'air from the packaging and connect the power cord
  2. Fill the water reservoir with cold tap water to the fill line and add about 4 squirts of w'air detergent
  3. Turn on your w'air (via the ON/OFF switch next to the power cord socket) and take the wand from its cradle
  4. Press the blue button and you’re ready to go!
  1. Carefully remove / wipe away any excess spillage then place your item on the backing mat on a hard, flat surface
  2. Make sure the w'air backing mat is directly under the stain (towel-side up)
  3. Check User Guide or w’air app to see if pre-treatment is required. If so, test on a small, discrete area first then apply liberally making sure you moisten the entire area of the stain
  4. Wait for the pre-treatment to completely dry before continuing (usually 10-15 minutes)
  5. Place the wand directly on top of the stain, press and hold the button and rub the area well
  6. Air dry in minutes and you’re ready to go
  7. If the stain doesn’t go, repeat from step 3 onwards
  8. Clean the wand thoroughly with warm water after use
  1. Lay your item onto a hard, flat surface
  2. Hold the wand as close as possible (without touching it) then press and hold the blue button on the wand
  3. Pass over the fabric paying particular attention to areas such as cuffs, collars and armpits on shirts and tops
  4. Rinse clean by dipping gently in cold water
  5. Hang out to dry naturally
  6. Clean the wand thoroughly with warm water after use
  1. Lay your item onto a hard, flat surface
  2. Hold the wand as close as possible (without touching it) then press and 
hold the blue button on the wand
  3. Pass over the fabric making sure all areas are refreshed
  4. Air dry in minutes and you’re ready to go
  5. Clean the wand thoroughly with warm water after use